Need Small Clamps

[Yorick]

The main joint into the pool pump split recently and I bodged it with big G-clamp.

I need a prettier and smaller solution. Maybe a small clamp on a nut and screw jobby. I know what I think, just can't explain.
The big clamp is gonna get knocked off, so want 2 or 3 smaller jobbies instead.

Any ideas?
.

20250208_150028.jpg (1.38 MiB) Viewed 695 times

[KungFooBob]

Or you could replace the broken part?

[Yorick]

Or you could replace the broken part?

All the joints have been glued. My plumber pal says he'll need to rip everything out and start again.
He's busy and want a better solution than I have now.

20250208_152037.jpg (1.19 MiB) Viewed 688 times

[Cousin Jack]

If that is working I might be inclined to try 3 small G clamps spaced around the rim.

Amazon do several sizes

[A_morti]

Broken up the link so I can post it:

https://www.amazon.
es/-/en/dp/B0CWH6Z7D9

[Skub]

What about a pipe clamp?

Leave the G clamp in position until the pipe clamp is tightened,then remove the G clamp.
https://www.fischer.co.uk/en-gb/product ... ipe-clamps

[Felix]

Measure the fucked part and buy some flange clamps or just go but the correct broken part.

[Skub]

Measure the fucked part and buy some flange clamps or just go but the correct broken part.

He sed flange.

fnaar.

[Le_Fromage_Grande]

What about nipple clamps?

[gremlin]

Can't help, but you should think about treating yourself to a nice pedicure.