The F350 Thread
- ZRX61
- Posts: 4946
- Joined: Tue Mar 17, 2020 4:05 pm
- Location: Solar Blight Valley
- Has thanked: 1442 times
- Been thanked: 1357 times
Re: The F350 Thread
Burnished the stainless Cat shield with a red fiber disc on an angle grinder... I may need an intervention.
- ZRX61
- Posts: 4946
- Joined: Tue Mar 17, 2020 4:05 pm
- Location: Solar Blight Valley
- Has thanked: 1442 times
- Been thanked: 1357 times
Re: The F350 Thread
Did more detailing under the truck. Trimmed a skosh off both ends of the tail-gate seat, finished with a 3/8 round-over bit in the router & then applied spar-varnish.
This is an older *before* pic:
*After* looks just like it, but a bit narrower.
This is an older *before* pic:
*After* looks just like it, but a bit narrower.
- ZRX61
- Posts: 4946
- Joined: Tue Mar 17, 2020 4:05 pm
- Location: Solar Blight Valley
- Has thanked: 1442 times
- Been thanked: 1357 times
- ZRX61
- Posts: 4946
- Joined: Tue Mar 17, 2020 4:05 pm
- Location: Solar Blight Valley
- Has thanked: 1442 times
- Been thanked: 1357 times
Re: The F350 Thread
More fucking sanding....
Today I'm working on the left front part...I'm at #220 dry so far.
Middle & rear pieces are already (mostly) done to #800 wet (thank fuck). Right front still needs work.
Today I'm working on the left front part...I'm at #220 dry so far.
Middle & rear pieces are already (mostly) done to #800 wet (thank fuck). Right front still needs work.
- ZRX61
- Posts: 4946
- Joined: Tue Mar 17, 2020 4:05 pm
- Location: Solar Blight Valley
- Has thanked: 1442 times
- Been thanked: 1357 times