Aprilia Caponord ETV1000 2007 (Gen 2).
It has four coils, two per cylinder, all the same. Bike appears to run fine at idle but under load bogs down quite badly. If running at idle and in the garage, it doesn't take long to get high on the petrol fumes so I guess there's unburnt fuel. One of the rear coil has a crack and you could see the spark arcing to the frame. I've tried wrapping it in rubber amalgamating tape but it's no better so I'm trying to source a reasonably priced replacements - Aprilia want £300 for a new one!
All suggested replacements (Renault Laguna V6, Clio V6 and Citreon V6) coils have a female connector on the coil whilst I need a male connector.
My questions - can the connections be swapped or adapted? I assume not. If not, could I not just swap out the HT lead for one that would fit? I've spent £130 on coils which *should* fit and am beginning to regret not phoning the Aprilia dealer to start with.
Ignition Coils
-
Beancounter
- Posts: 1009
- Joined: Sat Mar 14, 2020 1:20 pm
- Has thanked: 2869 times
- Been thanked: 554 times
-
Sadlonelygit
- Posts: 951
- Joined: Thu Mar 19, 2020 9:10 pm
- Has thanked: 85 times
- Been thanked: 687 times
-
Beancounter
- Posts: 1009
- Joined: Sat Mar 14, 2020 1:20 pm
- Has thanked: 2869 times
- Been thanked: 554 times
Re: Ignition Coils
Thank you, haven't seen that particular page before and it explains the "woodscrew" that I'd been reading about on the Aprilia forum. I have a few that I can practice on at least.Sadlonelygit wrote: ↑Mon Oct 14, 2024 2:38 pm https://www.moto-abruzzo.net/renault-v6 ... d-fitment/
-
Le_Fromage_Grande
- Posts: 11233
- Joined: Mon Mar 16, 2020 6:40 pm
- Location: The road of many manky motorcycles
- Has thanked: 607 times
- Been thanked: 4124 times
Re: Ignition Coils
In theory any coil of the right resistance will work, they only need the two wires connected, it doesn't matter which way round, and the HT lead to go to a spark plug.
Any HT lead will work.
Why not convert it to stick coils?
Any HT lead will work.
Why not convert it to stick coils?
-
KungFooBob
- Posts: 14196
- Joined: Sat Mar 14, 2020 1:04 pm
- Location: The content of this post is not AI generated.
- Has thanked: 539 times
- Been thanked: 7526 times
Re: Ignition Coils
EFALe_Fromage_Grande wrote: ↑Mon Oct 14, 2024 8:51 pm Why not have it set on fire, for a very reasonable £500 plus expenses?
-
Beancounter
- Posts: 1009
- Joined: Sat Mar 14, 2020 1:20 pm
- Has thanked: 2869 times
- Been thanked: 554 times
Re: Ignition Coils
Ta. It's already on stick coils. I was wondering if getting the 'right' coil was more to do with it fitting in the space rather than delivering the spark.Le_Fromage_Grande wrote: ↑Mon Oct 14, 2024 8:51 pm In theory any coil of the right resistance will work, they only need the two wires connected, it doesn't matter which way round, and the HT lead to go to a spark plug.
Any HT lead will work.
Why not convert it to stick coils?
Ouch. Given it fried its reg/rec a couple of months ago it may be trying to self-immolate.KungFooBob wrote: ↑Mon Oct 14, 2024 8:53 pmEFALe_Fromage_Grande wrote: ↑Mon Oct 14, 2024 8:51 pm Why not have it set on fire, for a very reasonable £500 plus expenses?
-
Rockburner
- Posts: 4374
- Joined: Sun Mar 15, 2020 11:06 am
- Location: Hiding in your blind spot
- Has thanked: 7810 times
- Been thanked: 2527 times
Re: Ignition Coils
I still don't understand why you keep standing in it's way....Beancounter wrote: ↑Tue Oct 15, 2024 10:54 am
Ouch. Given it fried its reg/rec a couple of months ago it may be trying to self-immolate.KungFooBob wrote: ↑Mon Oct 14, 2024 8:53 pmEFALe_Fromage_Grande wrote: ↑Mon Oct 14, 2024 8:51 pm Why not have it set on fire, for a very reasonable £500 plus expenses?
non quod, sed quomodo
-
Beancounter
- Posts: 1009
- Joined: Sat Mar 14, 2020 1:20 pm
- Has thanked: 2869 times
- Been thanked: 554 times
Re: Ignition Coils
Because up until August this year, the bike has been faultless.Rockburner wrote: ↑Tue Oct 15, 2024 11:19 amI still don't understand why you keep standing in it's way....Beancounter wrote: ↑Tue Oct 15, 2024 10:54 am
Ouch. Given it fried its reg/rec a couple of months ago it may be trying to self-immolate.
-
mangocrazy
- Posts: 6892
- Joined: Tue Dec 22, 2020 9:58 pm
- Has thanked: 2402 times
- Been thanked: 3625 times
Re: Ignition Coils
Have you thought of giving Griff Wooley at AP Workshops in Tamworth a call? I know he has used spares for Falcos, Milles, Tuonos etc. He may well know a cheaper workaround or alternative.
There is no cloud, just somebody else's computer.
Re: Ignition Coils
If he has some spares or a workaround, that could save me a lot.mangocrazy wrote: ↑Tue Oct 15, 2024 9:40 pm Have you thought of giving Griff Wooley at AP Workshops in Tamworth a call? I know he has used spares for Falcos, Milles, Tuonos etc. He may well know a cheaper workaround or alternative.