Valve collets

[Sadlonelygit]

Does this look like too large a gap to you?

IMG_20240901_170711.jpg (396.02 KiB) Viewed 1476 times

And secondly, I think there's room for improvement here!

IMG_20240901_170752.jpg (658.49 KiB) Viewed 1476 times

[Skub]

ISTR the gap being less on a 900R,but maybe it was just more equidistant. I can't see that gap being a problem though.

[Druid]

looks a bit big to me. This is my GS750

[Le_Fromage_Grande]

It does look a bit big, but they're not going to come out

[Sadlonelygit]

Personally I think it's just Indian build quality. The exhausts were roughly the same, so I knew they had seated properly.
Pretty sure the last top end I rebuilt had a better tolerance when built.....but it's been a while!

[iansoady]

I always try to get the gaps on each side the same although probably no real reason - it just looks nicer.....

[dern]

You could take the spring out and seat it all with hand tension. You'd know how it looks when it's all together then.

[Sadlonelygit]

Remember what I said about Indian build quality!
Looks like they got mice to make the bolt holes

IMG_20240903_160902.jpg (1.35 MiB) Viewed 1298 times

[porter_jamie]

Don't hog the exhaust out you will almost certainly make it worse unless you really know what you are doing. Do lots of reading, smokey yunick and Graham bell, before touching anything

[Sadlonelygit]

Don't hog the exhaust out you will almost certainly make it worse unless you really know what you are doing. Do lots of reading, smokey yunick and Graham bell, before touching anything

Thanks for your input, I've wielded a die grinder to good effect in the past!
Not my bike and the owner doesn't want to pay for anything he doesn't have too!

[Sadlonelygit]