Page 1 of 1
Yoshimura Copy Exhuast
Posted: Sun May 11, 2025 6:21 pm
by Felix
I got given this end can today. I have never seen a connection to the link pipe like this, Does the link pipe just slip on and held in place with the springs? Does not look like it would be a good seal if so.
- 20250511_180022.jpg (824.5 KiB) Viewed 323 times
- 20250511_180007.jpg (698.62 KiB) Viewed 323 times
Re: Yoshimura Copy Exhuast
Posted: Sun May 11, 2025 6:37 pm
by Lutin
Looks to me as if the cone inlet end would fit into a corresponding cone on the collector and, as you say, be held in place with springs.
Re: Yoshimura Copy Exhuast
Posted: Sun May 11, 2025 7:10 pm
by Le_Fromage_Grande
It looks truly awful, it also looks like it has a reducer cone in the inlet
Re: Yoshimura Copy Exhuast
Posted: Sun May 11, 2025 9:03 pm
by Felix
Apparently the cone is a reducer and pushed in. That comes out and im looking for a 51mm link pipe to fit my Black Widow downpipes. Probably will have to weld on loop for the springs to grab also
Re: Yoshimura Copy Exhuast
Posted: Sun May 11, 2025 11:07 pm
by Le_Fromage_Grande
What bike is it for, you can get 51mm link pipes off eBay
Re: Yoshimura Copy Exhuast
Posted: Mon May 12, 2025 12:40 am
by Felix
Le_Fromage_Grande wrote: Sun May 11, 2025 11:07 pm
What bike is it for, you can get 51mm link pipes off eBay
Its a Fazer 600 and going into a Black widow exhaust downpipes. I need to find my digital callipers to measure the downpipe O/D before i can order anything.
Re: Yoshimura Copy Exhuast
Posted: Tue May 13, 2025 9:21 pm
by Le_Fromage_Grande
Black Widow will probably sell you a link pipe
Re: Yoshimura Copy Exhuast
Posted: Wed May 14, 2025 2:56 pm
by Mr Moofo
It looks like a Remus hypercone
Re: Yoshimura Copy Exhuast
Posted: Wed May 14, 2025 6:27 pm
by Felix
Black Widow link pipe had to be 51.5mm O/D. Looks like it will all fist straight on as well. 51mm pipe ordered but i may have to weld on two spring hooks