Page 8 of 14
Re: The F350 Thread
Posted: Mon Sep 09, 2024 3:02 pm
by ZRX61
Rockburner wrote: Mon Sep 09, 2024 8:16 am
Jeez, you could have parked it better...
No tug boats available, luckily I had the entire parking lot to myself. Those two vehicles leaving were in the next parking lot.
Re: The F350 Thread
Posted: Wed Sep 11, 2024 9:32 pm
by ZRX61
Guide-coated & blocked out 5 pieces of the fiberglass with #220 dry. The pieces are now much straighter & ripple free. Threw some primer on the 4 smaller pieces.
Identified some spots on the back that need repair/reinforcement, but that won't impact the work on the front sides.
Will finish the two bigger pieces to this stage on Friday.
Once all 6 pieces are done to primer stage I'll guide coat again & prep with #400 wet.
Brackets are done...

Re: The F350 Thread
Posted: Fri Sep 13, 2024 10:17 pm
by ZRX61
Discovered that owing to the water based crap paint, I have to prep to #800 wet. Right now I'm at #320 dry on some parts, #220 dry on others #400 wet on one piece.
Checked the W&D stash.. #180, #240, #320, #400, #500, #600, #1000, #1200, #1500. #2000, #3000....but no #800
Arsebiscuits.
Will be sanding on the parts outside when I can work in the shade later in the day. Ordered some #800, will be here tomorrow.
Re: The F350 Thread
Posted: Mon Sep 16, 2024 10:37 pm
by ZRX61
Radiator header/expansion tank developed a leak, new one ordered.
Re: The F350 Thread
Posted: Tue Sep 17, 2024 6:25 pm
by v8-powered
Re: The F350 Thread
Posted: Tue Sep 17, 2024 6:29 pm
by Mr. Dazzle
Sold!

Re: The F350 Thread
Posted: Tue Sep 17, 2024 7:20 pm
by v8-powered
If i were that side of the pond, I'd be bidding!
Re: The F350 Thread
Posted: Tue Sep 17, 2024 7:40 pm
by Mr. Dazzle
It's the fact that a full sized VHS player doesn't absurdly huge which makes me laugh.
Oh and the fact it's installed in an 1990s MFI coffee table/hi-fi unit.

Re: The F350 Thread
Posted: Wed Sep 18, 2024 4:46 pm
by ZRX61
I notice they didn't include a pic of the underside of the dash. Centurion conversions are known for absolute birds nests of wiring (altho my Waldoch isn't much better)
Re: The F350 Thread
Posted: Sat Sep 21, 2024 7:07 pm
by ZRX61
Header/expansion tank swapped out. Known issue after 3 decades, they split at the seam.
The leaker:
The non-leaker:

Re: The F350 Thread
Posted: Sun Sep 22, 2024 5:47 am
by ZRX61
Ops chk ok.

Re: The F350 Thread
Posted: Sun Sep 22, 2024 7:08 am
by David
You aren't getting any better at parking.....
Re: The F350 Thread
Posted: Sun Sep 22, 2024 9:42 am
by cheb
It was the dog that done it.
Re: The F350 Thread
Posted: Sun Sep 22, 2024 12:23 pm
by Count Steer
ZRX61 wrote: Sun Sep 22, 2024 5:47 am
Ops chk ok.
Nice colour on the trees.

Re: The F350 Thread
Posted: Sun Sep 22, 2024 3:37 pm
by MingtheMerciless
ZRX61 wrote: Sun Sep 22, 2024 5:47 am
Ops chk ok.
You want to fit one of those fake EV charging ports so you can abandon it if front of half a dozen Tesla chargers

Re: The F350 Thread
Posted: Mon Sep 23, 2024 1:20 am
by ZRX61
Re: The F350 Thread
Posted: Mon Sep 30, 2024 5:29 am
by ZRX61
Removed, cleaned, painted & reinstalled the inspection cover on the (E4OD) trans. Used the same Steel-It paint I used for the rear axle, brake plates & pumpkin.
Before:
After:

Re: The F350 Thread
Posted: Mon Sep 30, 2024 7:12 pm
by ZRX61
MingtheMerciless wrote: Sun Sep 22, 2024 3:37 pm
You want to fit one of those fake EV charging ports so you can abandon it if front of half a dozen Tesla chargers
and one of the spoof car pool lane pass stickers...

Re: The F350 Thread
Posted: Wed Oct 02, 2024 1:09 am
by ZRX61
Lost my damn mind today... First you have to realize I'm home alone & unsupervised all week...
Started with a minor project involving the Griots G8 3in polisher/buffer to remove a couple of scratches by the lock on the drivers door...
Then...
I rolled under the truck & polished the oil pan...
and the bottom of the oil filter...

Re: The F350 Thread
Posted: Wed Oct 02, 2024 6:56 pm
by ZRX61
Pumpkin polishing...
Before:
5 minutes later:
