Getting Old Bar Grips Off?

[Yorick]

It appears that the grips on the mighty Husky have been glued on. After 10 moments cursing and swearing, the buggers still won't come off.

Is there a secret way ?

Do I need to buy new tubes?

What's for tea?

20210701_183657.jpg (1.58 MiB) Viewed 470 times

[Couchy]

We sometimes use compressed air with a small hose attachment. Normally works well

[Yorick]

We sometimes use compressed air with a small hose attachment. Normally works well

These buggers have been put on with some good glue. No way to get air in.

[cheb]

What solvents do you have to hand, or can get? Any of those might be worth a try. Probably easier buying a new throttle tube.

Acetone would be one of the first I'd try, somewhere that sell fibreglass might have it.

[DefTrap]

Judicious use of the wife's hairdryer?

[KungFooBob]

You need to buy new.

That bike is obviously well used, you need a newer one with nice new grips.

[Le_Fromage_Grande]

Cut them off with a Stanley knife, it's not like you're going to use them again

[Yorick]

Cut them off with a Stanley knife, it's not like you're going to use them again

Tried that. Glued all over.

[Yorick]

You need to buy new.

That bike is obviously well used, you need a newer one with nice new grips.

New bike next year.

[Rockburner]

It appears that the grips on the mighty Husky have been glued on. After 10 moments cursing and swearing, the buggers still won't come off.

Is there a secret way ?

Do I need to buy new tubes?

What's for tea?

20210701_183657.jpg

If it were mine, I'd buy a new throttle tube (or try to find a 2nd hand one), but cut the left side off as best as possible with a sharp knife. If they're as badly glued as they look then getting the new grip on the throttle tube is going to be awkward unless you get all the glue off cleanly, but with the left one you can be a bit more forceful when you put the new grip on.

[JackyJoll]

Heat gun and scraper.

[Yorick]

Finally got them cleaned and new grips fitted.

Then my pal says they come as a set.

https://www.odigrips.com/collections/mo ... grips-2723

[Screwdriver]

Integrated part. That's a one piece design. Probably not glued but solvent weld.

[Yorick]

Integrated part. That's a one piece design. Probably not glued but solvent weld.

I know that now

[Yorick]

IMG-20210709-WA0001.jpeg (993.01 KiB) Viewed 281 times

[KungFooBob]

Those bark busters have seen some action considering you don't have any trees :p

[Yorick]

Those bark busters have seen some action considering you don't have any trees :p

I just chuck it at the scenery willy nilly.